Environmental Information (WEEE)
This AMETEK product contains materials that can be reclaimed and recycled. In some cases the product
may contain materials known to be hazardous to the environment or human health. In order to prevent
the release of harmful substances into the environment and to conserve our natural resources, AMETEK
recommends that you arrange to recycle this product when it reaches its “end of life.”
Waste Electrical and Electronic Equipment (WEEE) should never be disposed of in a municipal waste sys-
tem (residential trash). The Wheelie Bin marking on this product is a reminder to dispose of the product
properly after it has completed its useful life and been removed from service. Metals, plastics and other
components are recyclable and you can do your part by one of the following these steps:
• When the equipment is ready to be disposed of, take it to your local or regional waste col-
lection administration for recycling.
• In some cases, your “end-of-life” product may be traded in for credit towards the pur-
chase of new AMETEK instruments. Contact your dealer to see if this program is available
in your area.
• If you need further assistance in recycling your AMETEK product, contact our office listed
in the front of the instruction manual.
PROTECTIVE CONDUCTOR TERMINAL
(BORNIER DE L’ECRAN DE PROTECTION)
Schutzerde
CAUTION - Risk of electric shock
(ATTENTION-RISQUE DE DÉCHARGE ÉLECTRIQUE)
Achtung - Hochspannung Lebensgefahr
CAUTION - Refer to accompanying documents
(ATTENTION-SE RÉFERER AUX DOCUMENTS JOINTS)
Achtung (Beachten Sie beiliegende Dokumente)
CAUTION - Hot Surface
(ATTENTION-SURFACE CHAUDE)
Achtung - Heiße Oberäche
Warning Labels
These symbols may appear on the instrument in order to alert you of existing conditions.
UV Source Lamps Disposal
AMETEK recommends that all UV lamps – whether they are new, used, or damaged in any way – need to
be disposed of in an environmentally safe manner.
Most UV lamps do not contain restricted substances listed under the European RoHS 2 directive.
However, special handling requirements are required for some lamps if they are broken. Refer to a current
Material Safety Data Sheet (MSDS) for handling any lamp where the glass envelope has been broken and
which has exposed the metal cathode in the centre of the lamp.
Contents | xiii
To Next Page
Loading...
Need help?
General
