Controller / User Interface | 4-7
During normal operation, the concentrations of the analytes can be dis-
played on the HOME screen. Other parameters that display real-time sys-
tem temperatures or pressures can also be displayed. Up to three analytes
or parameters can be displayed on the screen at one time. To view more
concentrations or other data, scroll up or down using the UP or DOWN ar-
row key.
The bottom line displays the main menu items which can be accessed by
pressing the corresponding keypad square (soft key) directly below each
item.
HOME Menu Screen
The HOME screen (Figure 4-2) allows the user to configure up to nine
analytes or parameters, whose real-time results will be displayed. These
parameters are displayed on the left side of this screen.
The right side of this screen displays the current operational status of the
analyzer. Descriptions of these states are described under “System Status
Messages (HOME Screen),” in the following pages. Also, new alarms and
warnings that have been set are displayed on this screen. Refer to “Alarm
and Warning Notification (HOME Screen),” later in this section, for more
information.
When you press ENTER, the software goes into Edit mode, allowing you to
set up the parameters that are displayed. Items that can be displayed here
include:
Heater (optional)
Displays the real-time temperature (°C) of the Oven Heater, as mea-
sured by the Oven Heater RTD (sealed inside the Oven Heater). This
parameter is available only for applications with a heated Oven.
Bench
Displays the real-time temperature (°C) of the Optical Bench, as mea-
sured by the Optical Bench RTD.
Figure 4-2.
HOME screen
(example).
Measure
Heater 21 °C
Bench 20 °C
Cell 23 °C
HOME ALARMS STATUS SETUP
To Next Page
Loading...
Need help?
General
