4-40 | IPS-4 Dual Bench (UV / IR) Analyzer
Figure 4-36.
Restore Factory
Settings screen.
Restore factory settings. Are you sure?
Press
for yes.
Press X for no.
HOME ALARMS STATUS SETUP
Figure 4-35.
Restore Settings
screen.
Restore settings. Are you sure?
Press
or yes.
Press X for no.
HOME ALARMS STATUS SETUP
3. Press ENTER to initiate the command to restore the settings. The soft-
ware will prompt: “Restore settings. Are you sure?” (Figure 4-35) or
“Restore factory settings. Are you sure?” (Figure 4-36).
• Press CANCEL (X) to answer no.
• Press ENTER ( ) to answer yes. The analyzer begins restoring con-
figuration settings from a file stored in the analyzer. The message
“Please wait ...” appears while the analyzer restores its settings.
- If you selected Restore settings, the analyzer begins restor-
ing its most recently saved configuration settings (when the
Backup settings command was last used) from a file called
“user.xml.”
- If you selected Restore factory settings, the analyzer begins re-
storing the original factory default configuration settings from
a file called “factory.xml.”
After the settings have been restored, the analyzer enables the set-
tings.
Cycle power to the Analyzer Off-On.
To Next Page
Loading...
Need help?
General
