Ametek IPS-4 User Manual

Specications | 2-15
IECEx Certificate of Conformity
Certificate No:
IEC Ex ETL
1
6.0044X
Issue No.
0
Annex No.
1
Certificate issued by:

3933 US Route 11 South
Cortland NY 13045-2995
United States of America
Page 1 of 1
Manufacturer’s documents
Drawings associated with Issue 0 of this certificate:
Title: Drawing No.: Rev. Level: Date:
Certification drawing IPS-4, Dual Bench, IECEx 403475903 A 11/9/2016
IPS-4 Analyzer Full Spectrum Option 1 Zone 1 User Manual 403469901 H --
Conditions of Manufacture (routine tests)
• IEC 60079-2 Section 17.1 Functional Test
• IEC 60079-2 Section 17.2 Leakage Test
Equipment Ratings: 120V/240V 50-60Hz 850Wmax
Purge Parameters:
Minimum Purging Flow Rate..................... 225 l/min
Minimum Purge Time............................... 5 Minutes
Protective Gas............................................ Air or Nitrogen
Minimum Supply Pressure............................ 4.15 bar (60psi)
Maximum Supply Pressure........................... 5 bar (72.5psi)
Maximum Leakage Rate........................... < 15 l/min
Minimum Overpressure.............................. 50 Pa (0,5 mBar)
Maximum Overpressure............................. 1000 Pa
Incorporated Ex Equipment/Components:
No.: Item: Manufacturer: Part No.: Details:
1
MiniPurge
Purge
Controller
EXPO
Technologies Ltd
071XLC/SS/PO
Certificate No.
IECEx SIR 07.0027X
Standards/Versions:
IEC 60079-0: 2011
IEC 60079-2: 2014
X/U Conditions:
From Cert:
1.these options not used
2.installed per instructions
3.safety parameters are set within
ratings
4. control unit is incorporated
correctly
5.low temperature option not used
6.no vortex cooler used
7.no vortex cooler used
Rating
Ex [pxb] IIC T6 Gb
Note
None

Ametek IPS-4 Specifications

General

Brand	Ametek
Model	IPS-4
Category	Measuring Instruments
Language	English