Anritsu MS2024B - 5-4 Graph Type Selector List Box

5-4 Graph Type Selector List Box Field Measurements
5-4 PN: 10580-00289 Rev. K Vector Network Analyzer MG
5-4 Graph Type Selector List Box
The Graph Type Selector list box is opened by pressing the Measurement Type soft key in the
Measure menu.
Field Measurements View versus VNA Measurements View
Three measurement display types are available in Field Measurements view: Single, Dual,
and Overlay. Press the Display Type soft key (submenu key).
In the Overlay display type, only two graph types are available, and they are Insertion Loss
for Trace 1 (TR1) and Return Loss for Trace 2 (TR2).
Figure 5-1 on page 5-5 provides an example of Insertion Loss in Display Type Single.
Figure 5-2 on page 5-6 provides an example of VSWR and Return Loss in Display Type Dual.
Figure 5-3 on page 5-7 provides an example of Insertion Loss and Return Loss measurements
in Display Type Overlay.
Field Measurements View
The following graph types are available in Field Measurements view:
When Display Type is set to Overlay, the graph types are always Insertion Loss for Trace 1
and Return Loss for Trace 2.
When Display Type is set to Single or Dual, the following graph types are available:
• VSWR
• Return Loss
• Cable Loss
• Insertion Loss
• 1-Port Phase
• 2-Port Phase
• 1-Port Smith
• DTF Return Loss
• DTF VSWR
VNA Measurements View
The following graph types are available in VNA Measurements view:
• Log Magnitude
• SWR
• Phase
• Real
• Imaginary
• Group Delay
• Smith Chart
• Inverted Smith Chart