181
8. Run the “netsh int ipv6 set address 5 2001::2” command to set the IP address.
The IP address set by this procedure is set to match the address set at [IPV6 Server IP Address] of the
MT8821C.
NOTE:
Places with contiguous 0s in the IPv6 Server IP Address captured at Index No IP Address of step 4 ‘netsh
int ipv6 set’ are abbreviated as::. For example IPv6 Server IP Address
2001:0000:0000:0000:0000:0000:0000:0002 displayed in the following screen is abbreviated to 2001::2.
Figure 5.1.2.2.1-6 IPv6 Address Setting Screen
9. Run the “ipconfig” command again to check that the IP address set at step 5 has been set correctly.
Figure 5.1.2.2.1-7 Server PC IP Configuration after IP Address Setting
To Next Page
Loading...
