Anritsu MT8820C - Page 49

49
2.2.3.1. MT8820C
2.2.3.1.1. Setting Example 1 (Intra-Band Contiguous FDD DL CA and UL CA)
This chapter describes a setting example for Duplex Mode set to FDD, Intra-Band DL CA and UL CA.
Set both Test Channel Bandwidth PCC and SCC to 20 MHz.
1. [PCC/SCC] Execute PRESET to initialize parameters.
2. [PCC] Execute CHCODING RMC_DLUL_CA_PCC to set Common Parameter - Channel Coding to RMC(DL/UL
CA-PCC).
3. [PCC] Execute CALLPROC ON to set Common Parameter - Call Processing to ON.
4. [PCC] Execute DLCHAN 200 to set Common Parameter - Frequency - DL Channel to 200 simultaneously
with UL Channel to 18200.
5. [PCC] Execute DLCHAN_SCC1 398 to set Call Processing Parameter - Carrier aggregation SCC-1 - DL
Channel to 398
6. [PCC] Execute BANDWIDTH 20MHZ to set Common Parameter - Frequency - Channel Bandwidth to 20
MHz.
7. [PCC] Execute BANDWIDTH_SCC1 20MHZ to set Call Processing Parameter - Carrier aggregation SCC-1 -
Channel Bandwidth to 20 MHz.
8. [SCC-1] Execute CHCODING RMC_DLUL_CA_SCC to set Common Parameter - Channel Coding to RMC
(DL/UL CA - SCC).
9. [SCC-1] Execute CALLPROC OFF to set Common Parameter - Call Processing to OFF.
10. [SCC-1] Execute DLCHAN 398 to set Common Parameter - Frequency - DL Channel to 398 simultaneously
with UL Channel to 18299.
11. [SCC-1] Execute BANDWIDTH 20MHZ to set Common Parameter - Frequency - Channel Bandwidth to 20
MHz.
2.2.3.1.2. Setting Example 2 (Inter Band FDD DL CA without UL CA)
This chapter describes a setting example for Duplex Mode set to FDD, Inter-Band DL CA without UL CA.
1. [PCC/SCC] Execute PRESET to initialize parameters.
2. [PCC] Execute CHCODING RMC_DL_CA_PCC to set Common Parameter - Channel Coding to RMC(DL
CA-PCC).
3. [PCC] Execute CALLPROC ON to set Common Parameter - Call Processing to ON.
4. [PCC] Execute DLCHAN 200 to set Common Parameter - Frequency - DL Channel to 200 simultaneously
with UL Channel to 18200.
5. [PCC] Execute DLCHAN_SCC1 2525 to set Call Processing Parameter - Carrier aggregation SCC-1 - DL
Channel to 2525.
6. [PCC] Execute BANDWIDTH 10MHZ to set Common Parameter - Frequency - Channel Bandwidth to 10
MHz.
7. [PCC] Execute BANDWIDTH_SCC1 10MHZ to set Call Processing Parameter - Carrier aggregation SCC-1 -
Channel Bandwidth to 10 MHz.
8. [SCC-1] Execute CHCODING RMC_DLUL_CA_SCC to set Common Parameter - Channel Coding to RMC
(DL/UL CA - SCC).
9. [SCC-1] Execute CALLPROC OFF to set Common Parameter - Call Processing to OFF.
10. [SCC-1] Execute DLCHAN 2525 to set Common Parameter - Frequency - DL Channel to 2525.
11. [SCC-1] Execute BANDWIDTH 10MHZ to set Common Parameter - Frequency - Channel Bandwidth to 10
MHz.