Anritsu MT8820C - Page 50

50
2.2.3.1.3. Setting Example 3 (Intra-Band TDD DL CA without UL CA)
This chapter describes a setting example for Duplex Mode set to TDD, Intra-Band DL CA without UL CA.
The Uplink/Downlink Configuration is set to 1, and Special Subframe Configuration is set to 4.
Follow the procedure in Chapter 2.2.3.1.2 replacing Step 4, 5, 10 and 11, followed by Step 14 and 15 as below.
4. [PCC] Execute DLCHAN 38000 to set Common Parameter - Frequency - DLChannel simultaneously with UL
Channel to 38000.
5. [PCC] Execute DLCHAN_SCC1 38099 to set Call Processing Parameter - Carrier aggregation SCC-1 - DL
Channel to 38099.
10. [SCC-1] Execute ULCHAN_PCC 38000 to set Call Processing Parameter - Carrier aggregation PCC - UL
Channel to 38000.
11. [SCC-1] Execute DLCHAN 38099 to set Common Parameter – Frequency - DL Channel to 38099.
14. [PCC/SCC] Execute TDDULDLCONF 1 to set Common Parameter - TDD Uplink/Downlink Configuration to
1.
15. [PCC/SCC] Execute TDDSSFCONF 4 to set Common Parameter - TDD Special Subframe Configuration to 4.
NOTE 1: Set same value as Uplink/Downlink Configuration in PCC and SCC.
NOTE 2: Set same value as Special Subframe Configuration in PCC and SCC.
2.2.3.1.4. Setting Example 4 (Inter-Band TDD DL CA and UL CA)
This chapter describes a setting example for Duplex Mode set to TDD, Inter-Band DL CA and UL CA
The Uplink/Downlink Configuration is set to 2, and Special Subframe Configuration is set to 5.
Follow the procedure in Chapter 2.2.3.1.1 replacing with Step 4, 5, 10 and 11, followed by Step 12 and 13 as below.
4. [PCC] Execute DLCHAN 38000 to set Common Parameter - Frequency - DL Channel simultaneously with
UL Channel to 38000.
5. [PCC] Execute DLCHAN_SCC1 39150 to set Call Processing Parameter - Carrier aggregation SCC-1 - DL
Channel to 39150.
10. [SCC-1] Execute DLCHAN 39150 to set Common Parameter - Frequency - DL Channel simultaneously with
UL Channel to 39150.
12. [PCC/SCC] Execute TDDULDLCONF 2 to set Common Parameter - TDD Uplink/Downlink Configuration to
2.
13. [PCC/SCC] Execute TDDSSFCONF 5 to set Common Parameter - TDD Special Subframe Configuration to 5.
NOTE 1: Set same value as Uplink/Downlink Configuration in PCC and SCC.
NOTE 2: Set same value as Special Subframe Configuration in PCC and SCC.