Calibration
125
Softkey Comments
Read
1
Read old factor from controller/tool.
Save
2
Save new calculated factor in
controller/tool. Tightening operations are
marked used in calibration. Printout
question is asked.
Done
3
Mark tightening operations as used in
calibration. Printout question is asked.
Cancel Close window.
Target Update target torque.
Edit Change the calculated factor.
1
Only if “RS232” or “Infrared” communication is selected.
2
Only if “RS232" or “Infrared” communication is selected.
3
Only if “Manual input” communication is selected. Replaces “Save”.
To Next Page
Loading...
