Programming
57
8.6.3 Delete Tool
This function will allow you to delete the selected tool or all tools (including their tightening data) in the
database.
The delete function affects the current tool selected; i.e. the tool currently displayed. Therefore, to delete
a tool, first select the tool and then use this function to delete it.
1. Open the Datab. menu block again.
2. Highlight function 3. Delete Tool and press ‘Enter’. Choose Select Tool or
All Tools.
A warning box appears confirming this function and asking “Are you sure?”
3. Check that the tool ID in the measurement dialog box is the tool you want to
delete.
§ If it is not the correct tool ID, press ‘Enter’ to exit this dialog box and
return to the measurement dialog box.
§ If it is correct, use the arrows to highlight OK and then press ‘Enter’ or
press the ‘OK’ button on the keypad. A pop-up dialog box flashes
confirming the deleting process.
The tool that was displayed has now been deleted along with all its tightening data and you return
automatically to the measurement dialog box. The measurement dialog box now displays the saved tool
in your database immediately before the one that you just deleted.
Note!
It is not possible to delete the default tool, tool number 1, in your database.
To Next Page
Loading...
