Programming
42
8.3 Configuration (Conf.)
Available in Basic, Quality Control and Advanced Analysis versions.
Note!
Shaded areas are only available in QC and AA.
To begin with, use the “Conf.” menu block to configure the basic parameters on your
ACTA 3000. In this menu block you have the following parameters.
Conf.
1. Interface--------- 1. User 1 Backlight
2 Contrast
3 Language
4 Password
2. Tightening operations 1 Torque units
2 Pulse units
3 Buzzer
4 Data
5 Time
6 Torque Value
7 Routing
8 New seq. No.
3. Port 1 Printer protocol
2 Paper size
3 Colour
4 Baud rate
5 Flow control
6 Bar code position
7 Bar code length
2. Calibration------ 1 ACTA
2 Deadweight
3 Tool
To Next Page
Loading...
