Programming
84
8.15 Parameters (Param.)
Available in Advanced Analysis versions.
Set your ACTA 3000 AA to trace measurement dialog box mode. This function will allow you to select
between four different trace modes:
1. Torque(angle) Torque over angle
2. Torque(time) Torque over time
3. Angle(time) Angle over time
4. Torque, angle(time) Torque and angle over time
1. Open the Param. menu block and a pop-up dialog box appears with the
above options.
2. Select graph mode by highlighting your selection using the arrows and then
pressing ‘Enter’. You can also select graph mode by simply pressing the
number corresponding to each graph mode on the keypad.
Your selection is made and the ACTA 3000 uses the new graph mode as a
standard until the operation above is repeated and another graph mode is
selected.
To Next Page
Loading...
