ToolsTalk ACTA
151
13.5 Automatic Calibration and Maintenance
Reminder
Every time you start ToolsTalk ACTA you can have it display all the tools that
need calibration and preventive maintenance. You just set the preferences
when creating each tool and ToolsTalk ACTA will then do the rest.
Even better than the reminder is performing the actual calibration
which couldn’t be easier.
A short demonstration…
1. ToolsTalk ACTA indicates at startup which tools need
calibrating.
2. Simply download the above tools to your ACTA 3000.
3. Perform the calibration…and transfer the new tightening data for
each tool back to ToolsTalk ACTA. Everything is saved and
organised.
To Next Page
Loading...
