Programming
60
8.8 Program (Prog.)
Available in Basic, Quality Control and Advanced Analysis versions, see the table below.
This is the menu block containing the programming tree for all measurement parameters and the
statistical parameters for your database.
If you have the ToolsTalk ACTA software and a QC or AA ACTA 3000, you can also use them to
perform this function. Refer to the ToolsTalk ACTA manual for instructions.
On the next page is a full description of all the functions found under the program menu block. Refer
also to the programming tree chart.
Note!
Shaded areas are only available in QC & AA.
Prog.
1. Tool type setup----------------
1 Tool type
2 Target torque
3 Controller
4 Calibration torque/Tuning factor
5 Communication
6 Parameter set
7 Cell ID/Unit ID
8 Channel
9 Model
2. Measurement setup----------- 1 Filter freq.
2 Rotation direction
3 Measure strategy
3. Ext. measurement setup----- 1 Cycle start
2 Cycle complete
3 Start angle
4 Angle complete
5 Measurement delay time
6 Reset time
7 End time
8 Slip torque
To Next Page
Loading...
