Technical Specifications
173
15.6.5 Click Wrench
This setup is obtained when carrying out quick programming with a Click Wrench (Q.Prog-4).
Click wrench
Tool type Click wrench
Target torque 0.75 * Transducer calibration torque * Transducer torque span
Calibration torque 0.75 * Transducer calibration torque * Transducer torque span
Parameter set 0
Controller None
Communication Manual input
Cell ID 0
Channel 1
Model Tensor S
Filter frequency 1000 Hz
Rotation direction CW
Measure strategy Break away
Cycle start 0.05 * Transducer calibration torque
Cycle complete 0.10 * Transducer calibration torque
Start angle 0.12 * Transducer calibration torque
Angle complete Peak torque
Measure delay time 0 ms
Reset time 0 ms
End time 400 ms
Slip torque 0.04 * Transducer calibration torque
Batch size 0
Subgroup size 5
Subgroup frequency 1
Batch result Off
Torque min. 0.05 * Transducer calibration torque
To Next Page
Loading...
