Atlas Copco ACTA 3000

Quick Programming
18
4.3 Quick programming
1. Select menu block Q.Prog. on the display by pressing the softkey below it.
A pop-up menu appears with five alternatives:
Q. Prog
1 Direct driven
2 Pulse
3 Wrench
4 Click wrench
5 Synchronise-------- 1 None
2 Other controller
3 Focus 2000/PF2000--------
1 Manual input
2 RS232
4 DS--------------------------
--
1 Manual input
2 Infrared
3 RS232
5 PF3000 1 Manual input
2 Infrared
3 RS232
6 PowerMacs 1 Manual input
2 RS232
2. Select the type of tool you are using by using the arrows to highlight your
choice. Press ‘Enter’. You can also select the tool type by pressing the
number shown for each tool type on the keypad.
Direct driven Used when testing all types of direct driven tools dynamically.
Pulse Used when testing all types of direct driven tools dynamically.
Wrench Used when checking installed torque in an already tightened joint.
Click wrench Used when checking the release torque on a Click Wrench.