Technical Specifications
165
15.5 Barcode Reader
A Barcode Reader (BCR) is used to select tools in the database or set the
sequence number.
If a tool message from the BCR equates to a Tool ID in the database, ACTA
selects that tool.
Message layout tool ID:
STX ? ? Tool ID ETX
A sequence number message from the BCR sets the sequence number to the
code starting position “Barcode position” with the length “Barcode length”. The
“Barcode position” and “Barcode length” are configuration parameters. Use the
“Configuration” menu to set these parameters.
Message layout sequence number:
STX Sequence no. ETX
Barcode. The set-up for the reader is:
Baud rate 9600
Parity None
# of stopbits 1
# of databits 8
Flow control None
Stop character STX .... ETX
ACK / NAK On
Xon/Xoff Off
RTS/CTS Off
To Next Page
Loading...
