Quick Programming
21
4.4 Your Measurement Results using Quick
Programming
10 11 7 12 1
1. Number of tightenings 7. Name of tool
2. X-bar 8. Number of pulses
3. Confidence interval neg. 9. Last five tightenings
4. Confidence interval pos. 10. Power left in battery
5. Measured torque 11. Communication
6. Measured angle 12. Filter frequency
Start measuring.
After a few tightening operations the display should appear as shown below.
Note!
The symbol to the right of the battery symbol indicates the type of communication selected
(ToolsTalk, Focus 2000/PF2000 serial, PF 3000 serial or infrared, DS serial or DS
infrared). This symbol is only displayed in QC & AA ACTA 3000 (Basic ACTA 3000
does not have the ability to communicate).
Display Parameter Explanation
1. Number of tightening operations The number of tightening operations that have been performed.
2. X-bar The average of all the measurements that have been performed.
Located in the memory.
To Next Page
Loading...
