Quick Programming
20
PF3000 Graph infrared:
A text window on the screen says:
“IR connect requested from ACTA 3000 on local channel 0. Press ‘OK’ to acknowledge,
wait or cancel to refuse.”
Press ‘OK’ on the PF. A new message appears:
“IR connect requested from ACTA 3000 on local channel 0. Press ‘OK’ to acknowledge,
wait or cancel to refuse.”
The selected tool in the ACTA 3000 will then be programmed with the settings
from the controller.
Note!
If Focus 2000/PF2000 automatic tool calibration (Q.Prog.-5-3-2) is selected,
an input menu requesting the unit ID appears in the ACTA 3000 display. Enter
the controller unit ID and press ‘Enter’.
5. Use the arrows again to highlight OK and press ‘Enter’ or simply press the
‘OK’ button on the keypad.
6. Another dialog box flashes confirming that default programming is now
being used. Programming is complete – you are ready to start measuring.
To Next Page
Loading...
