Installation and startup
15
3. Installation and startup
3.1 Out of the Box
When purchasing any version of ACTA 3000, the following should be included:
§ V AC Power Supply Cable
§ Manual /ASL
§ Calibration Certificate.
Please keep the calibration certificate as it might be useful ID when servicing your
ACTA 3000 in the future.
3.1.1 Installation
The ACTA 3000 is a stand-alone portable product. Therefore, no particular
installation is necessary. Simply follow the safety instructions and observe the
following recommendations:
§ Place the ACTA 3000 on a firm, flat surface or hold it securely in your hand
§ Connect your Atlas Copco memory transducer
§ Connect the power supply cable
§ Start the ACTA 3000 by pressing and holding the ‘On’ button until the
buzzer sounds.
The first time you charge the battery, please charge it for 12 hours and then use
the ACTA 3000 in battery mode until the battery is totally drained.
The ACTA 3000 features an internal charger which can be used during charging
if connected to a V AC outlet.
To Next Page
Loading...
