Atlas Copco ACTA 3000

Installation and startup
16
Power Supply Port Transducer Port
To install other accessories, such as a printer, oscilloscope etc., or find out how to
connect them to a PC, see the connector diagram in the Technical Information
section.
Startup
When you start the ACTA 3000, the following will appear in the display dialog
box:
• The Atlas Copco logo flashes
• The Measurement dialog box appears
• The Calibration dialog box flashes (if an Atlas Copco memory transducer is
connected)
• The Measurement dialog box resumes.
The ACTA 3000 initialises and performs a self-test. The calibration dialog box
appears in order to indicate that the ACTA 3000 is communicating with the
Atlas Copco memory transducer and performing an automatic setup. It reads
the transducer’s serial number and calibration data, which it stores in its
memory.
Note!
The ACTA 3000 can operate with most types of transducer. If you use an Atlas Copco
non-memory transducer or other brand, refer to the Technical Specifications section on
how to set up your transducer before continuing with Quick Programming in the next
section.
Connector Panel
For a complete technical
specification of the
connectors, see the
Technical Specifications
section