Technical Specifications
175
15.6.6 Synchronise
None controller
Tool type Depending on selections
Target torque Depending on selections
Calibration torque 0.75 * Transducer calibration torque * Transducer torque span
Parameter set 0
Controller None
Communication Manual input
Cell ID 0
Channel 1
Model None
Filter frequency Depending on selections
Rotation direction CW
Measure strategy Depending on selections
Cycle start 0.05 * Transducer calibration torque
Cycle complete 0.10 * Transducer calibration torque
Start angle 0.12 * Transducer calibration torque
Angle complete Peak torque
Measure delay time 0 ms
Reset time 0 ms
End time 400 ms
Slip torque
11
0.1 Nm
Batch size 0
Subgroup size 5
Subgroup frequency 1
Batch result Off
Torque min. 0.05 * Transducer calibration torque
11
Not used for wrench.
To Next Page
Loading...
