Quick Programming
19
3. You are now asked if you want to use default programming.
Note!
If Pulse is selected, an input menu appears in the ACTA display asking for the
filter frequency. Enter the frequency and press ‘Enter’.
If Wrench is selected, a list menu appears where you can select between Peak
torque or Static installed torque.
Read more about strategies in Chapter 0.
Note!
Shaded areas are only available in QC & AA.
4. When using “Synchronise”, the ACTA 3000 will be programmed to
measure the torque similar to the controller. After each tightening operation
the ACTA 3000 will either ask the operator for or read the tightening
values directly from the controller, depending on the programming (manual
input, infrared or RS232).
Note!
If “none” or “other” controller is selected, a pop-up menu appears where the type of tool can be
selected. For “none” controlled tool an input menu appears requesting the target torque. For “other”
controller tool the calibration torque should be input. Select Pulse tool and another question appears
requesting the filter frequency. Select Wrench and another question appears requesting the measure
strategy.
Note!
If infrared or RS232 is selected, the ACTA 3000 will try to communicate with the controller and read
the settings. Therefore, make sure that this is possible, either by connecting an Atlas Copco serial cable
between the controller and the ACTA 3000 (RS232) or by pointing the ACTA 3000 towards the
controller display (infrared).
DS infrared:
DS drive will start to blink “- -“, “ -- “. Press the ‘Enter’ button (the arrow) until the display
starts to blink “Ir”.
PF3000 Compact infrared:
PF drive will start to blink “-Ir-“, “ “. Press the ‘Enter’ button (the arrow) until the display
starts blinking “-Ir-“, “ Ir “.
To Next Page
Loading...
