Calibration
128
Softkey Comments
Read
4
Read values from controller.
Save
5
Save new calculated calibration torque in
controller. Tightening operations are
marked used in calibration. Printout
question is asked.
Done
6
Mark tightening operations as used in
calibration. Printout question is asked.
Cancel Close window.
Edit Change the calibration torque.
4
Only if “RS232” or infrared communication is selected.
5
Only if “RS232” or infrared communication is selected.
6
Only if “Manual input” communication is selected. Replaces “Save”.
To Next Page
Loading...
