Technical Specifications
177
Other controller
Tool type Depending on selections
Target torque 0.75 * Transducer calibration torque * Transducer torque span
Calibration torque Depending on selections
Parameter set 0
Controller Other controller
Communication Manual input
Cell ID 0
Channel 1
Model None
Filter frequency Depending on selections
Rotation direction CW
Measure strategy Peak
Cycle start 0.05 * Transducer calibration torque
Cycle complete 0.10 * Transducer calibration torque
Start angle 0.12 * Transducer calibration torque
Angle complete Peak torque
Measure delay time 0 ms
Reset time 0 ms
End time 400 ms
Slip torque
12
0.1 Nm
Batch size 0
Subgroup size 5
Subgroup frequency 1
Batch result Off
Torque min. 0.05 * Transducer calibration torque
12
Not used for direct driven tool.
To Next Page
Loading...
