Atlas Copco ACTA 3000

Technical Specifications
181
2. RS232
F2000/PF2000
Tool type Direct driven
Target torque Read from controller
Calibration torque Read from controller
Parameter set Read from controller
Controller F2000/PF2000
Communication RS232
Unit ID Depending on selections
Channel 1
Model Tensor S
Filter frequency 500 Hz
Rotation direction CW
Measure strategy Peak
Cycle start Read from controller
Cycle complete Read from controller
Start angle Read from controller
Angle complete Read from controller
Measure delay time Read from controller
Reset time Read from controller
End time Read from controller
Slip torque
14
0.1 Nm
Batch size Read from controller
Subgroup size Read from controller
Subgroup frequency 1
Batch result Read from controller
Torque min. Read from controller
Torque max. Read from controller
Torque LCLx -9999.0
Torque UCLx 9999.0
Torque LCLr 0.0
14
Not used for direct driven tool.