Atlas Copco ACTA 3000

Programming
46
3. Buzzer Allows you to set/select the functionality of the buzzer signal. (i.e. when the
buzzer should sound).
You can choose between:
1. Off
2. Each tightening operation
3. Nok tightening (only in QC and AA)
4. Batch complete (only in QC and AA)
5. New tool (only in QC and AA)
6. Torque > min. (only in QC and AA)
Note!
The “Nok tightening” option means that the buzzer sounds if the tightening value
is outside the limits programmed in “Prog.-4-2”, “Prog.-4-3” and “Prog.-4-4”.
The “Torque > min” option means that when the torque rises above the torque
min. limit during a tightening operation (Prog.-4-2-1) the buzzer will sound.
4. Time Here you input the current time manually.
5. Torque value Allows you to set the number of digits displayed in the torque value. You can
choose between 3, 4 or 5 digits.
6. Routing
Note!
Routing is only available in QC and AA.
Sets the ACTA 3000 to select the next tool in your Database automatically when
you have completed a batch with the current tool. You can select:
Off
Tool
Job
7. New seq. No.
Note!
Only available in QC and AA.
Sets the ACTA 3000 to ask for a new sequence number. You can select:
Off
Tool
Job
Always