Programming
48
Tool Batch Tightenings
size 1 2 3 4
BMX495 2
• •
RTN691\1 3
• • •
RTN691\8 4
• • • •
RTN691\2 2 • •
TSX312\1 2
• •
TSX312\2 3
• • •
KLT658\7 2
• •
BGT618 3
• • •
About New Sequence number
A new sequence number question may be asked automatically after a completed tightening
operation. Whether or not this question will be displayed depends on the parameter
selected.
Note!
The sequence number may be input from the keypad or with a barcode reader. Barcode
communication must be initiated before input from the barcode reader will be possible.
Off
No new sequence number needs to be input after a complete tightening operation when Off
is selected.
Tool
When the Tool parameter is selected, a question will be displayed automatically each time a
new tool is selected.
Job
When Job is selected, a question will be displayed automatically each time a new tightening
operation is selected for the tool. See Job routing above.
Always
When Always is selected, a question will be displayed automatically after each completed
tightening operation.
To Next Page
Loading...
