Programming
78
Pulse units
Sets the units used for the pulse in this tool.
1. Number of
2. Hz
Comments, rows 5 & 6
In the lower part of the ACTA 3000 custom display dialog box there are two
rows for comments. These two rows are configured separately. You can enter
your own free text of a maximum of 20 characters for each row, or choose from
pre-defined options in ToolsTalk ACTA. Refer to the ToolsTalk ACTA manual
for detailed information.
Comments row 1 You can enter your own free text or see ToolsTalk
ACTA.
Comments row 2 You can enter your own free text or see ToolsTalk
ACTA.
Setting the Display Setup
1. Open the “Prog.” menu block and select (open) 5. Display setup.
2. Use the arrows to highlight (select) the above parameters. Open each
parameter by pressing ‘Enter’.
3. Select your option under parameters 1-4 or manually input your text using
the key in parameters 5-6. Press ‘Enter’ to confirm each input.
4. When all parameters have been set according to your preference, highlight
OK and press ‘Enter’ or simply press the ‘OK’ button on the keypad.
Display setup is now complete and saved. The Display setup pop-up dialog box
disappears and the measurement dialog box returns.
If you need to exit Display setup prematurely before setting your preferences,
highlight Cancel and then press ‘Enter’ or simply press the menu block showing
Cancel. None of the preferences for the above parameters will then take effect.
To Next Page
Loading...
