SIP User's Manual 164 Document #: LTRT-65415
MediaPack Series
Parameter Description
Destination Host
[IP2IPRouting_DestHost]
The host part of the incoming SIP INVITE’s destination URI
(usually the Request URI). If this rule is not required, leave
the field empty. The asterisk (*) symbol can be used to
depict any destination host.
The default is "*".
Request Type
[IP2IPRouting_RequestType]
The type of incoming SIP request:
[0] All (default)
[1] INVITE
[2] REGISTER
[3] SUBSCRIBE
[4] INVITE & REGISTER
[5] INVITE & SUBSCRIBE
Operation Routing Rule (performed when match found in above characteristics)
Destination Type
[IP2IPRouting_DestType]
Determines the destination type to which the outgoing
INVITE is sent.
[0] IP Group (default) = The INVITE is sent to the IP
Group’s Proxy Set (if the IP Group is of SERVER type) \
registered contact from the database (if USER type).
[1] Dest Address = The INVITE is sent to the address
configured in the following fields: 'Destination Address',
'Destination Port', and 'Destination Transport Type'.
[2] Request URI = The INVITE is sent to the address
indicated in the incoming Request-URI. If the fields
'Destination Port' and 'Destination Transport Type' are
configured, the incoming Request-URI parameters are
overridden and these fields take precedence.
[3] ENUM = An ENUM query is sent to include the
destination address. If the fields 'Destination Port' and
'Destination Transport Type' are configured, the incoming
Request URI parameters are overridden and these fields
take precedence.
Destination IP Group ID
[IP2IPRouting_DestIPGroupID]
The IP Group ID to where you want to route the call. The
INVITE messages are sent to the IP address(es) defined for
the Proxy Set associated with this IP Group. If you select an
IP Group, it is unnecessary to configure a destination IP
address (in the 'Destination Address' field). However, if both
parameters are configured, the IP Group takes precedence.
If the destination IP Group is of USER type, the device
searches for a match between the Request-URI (of the
received INVITE) to an AOR registration record in the
device's database. The INVITE is then sent to the IP
address of the registered contact.
The default is -1.
Note: This parameter is only relevant if the parameter
'Destination Type' is set to 'IP Group'. However, regardless
of the settings of the parameter 'Destination Type', the IP
Group is still used - only for determining the IP Profile
To Next Page
Loading...
Need help?
General
