SIP User's Manual 336 Document #: LTRT-65415
MediaPack Series
Parameter Description
VLAN Parameters
Web/EMS: VLAN Mode
[VLANMode]
Enables the VLAN functionality.
[0] Disable (default).
[1] Enable = VLAN tagging (IEEE 802.1Q) is enabled.
Notes:
For this parameter to take effect, a device reset is required.
To operate with multiple network interfaces, VLANs must be
activated.
VLANs are available only when booting the device from
flash. When booting using BootP/DHCP protocols, VLANs
are disabled to allow easier maintenance access. In this
scenario, multiple network interface capabilities are not
available.
Web/EMS: Native VLAN ID
[VLANNativeVLANID]
Defines the VLAN ID to which untagged incoming traffic is
assigned. Outgoing packets sent to this VLAN are sent only with
a priority tag (VLAN ID = 0).
When this parameter is equal to one of the VLAN IDs in the
Multiple Interface table (and VLANs are enabled), untagged
incoming traffic is considered as incoming traffic for that
interface. Outgoing traffic sent from this interface is sent with
the priority tag (tagged with VLAN ID = 0).
When this parameter is different from any value in the 'VLAN ID'
column in the table, untagged incoming traffic is discarded and
all outgoing traffic is tagged.
Note: If this parameter is not set (i.e., default value is 1), but
one of the interfaces has a VLAN ID configured to 1, this
interface is still considered the ‘Native’ VLAN. If you do not wish
to have a ‘Native’ VLAN ID and want to use VLAN ID 1, set this
parameter to a value other than any VLAN ID in the table.
[EnableDNSasOAM]
Determines the application type for DNS services.
[1] = OAMP (default)
[0] = Control.
Note: For this parameter to take effect, a device reset is
required.
[EnableNTPasOAM]
Determines the application type for NTP services.
[1] = OAMP (default)
[0] = Control.
Note: For this parameter to take effect, a device reset is
required.
[VLANSendNonTaggedOnNative]
Determines whether to send non-tagged packets on the native
VLAN.
[0] = Sends priority tag packets (default).
[1] = Sends regular packets (with no VLAN tag).
Note: For this parameter to take effect, a device reset is
required.
To Next Page
Loading...
Need help?
General
