Version 6.2 407 February 2011
SIP User's Manual 10. Configuration Parameters Reference
Parameter Description
IpProfile_SBCDivers
ionMode
Diversion Mode -
IpProfile_SBCHistor
yInfoMode
History Info Mode
-
The parameter IpPreference determines the priority of the IP Profile (1 to
20, where 20 is the highest preference). If both IP and Tel Profiles apply
to the same call, the coders and common parameters (i.e., parameters
configurable in both IP and Tel Profiles) of the preferred profile are
applied to that call. If the Tel and IP Profiles are identical, the Tel Profile
parameters take precedence.
The parameter CallLimit defines the maximum number of concurrent calls
allowed for that Profile. If the Profile is set to some limit, the device
maintains the number of concurrent calls (incoming and outgoing)
pertaining to the specific Profile. A limit value of [-1] indicates that there is
no limitation on calls (default). A limit value of [0] indicates that all calls
are rejected. When the number of concurrent calls is equal to the limit, the
device rejects any new incoming and outgoing calls pertaining to that
profile.
RxDTMFOption configures the received DTMF negotiation method: [-1]
not configured, use the global parameter; [0] don’t declare RFC 2833; [1]
declare RFC 2833 payload type is SDP.
FirstTxDtmfOption and SecondTxDtmfOption configures the transmit
DTMF negotiation method: [-1] not configured, use the global parameter;
for the remaining options, see the global parameter.
The VxxTransportType parameter configures the modem transport type
per IP Profile for the following parameters: V21ModemTransportType,
V22ModemTransportType, V23ModemTransportType,
V32ModemTransportType, and V34ModemTransportType.
IP Profiles can also be used when operating with a Proxy server (set the
parameter AlwaysUseRouteTable to 1).
The following parameters are not applicable: IsDTMFUsed (deprecated),
SBCExtensionCodersGroupID, TranscodingMode
SBCAllowedCodersGroupID, SBCAllowedCodersMode,
SBCMediaSecurityBehaviour, SBCRFC2833Behavior,
SBCAlternativeDTMFMethod, SBCAssertIdentity, SBCDiversionMode,
SBCHistoryInfoMode, AddIEInSetup MediaIPVersionPreference
For a description of using ini file table parameters, see ''Configuring ini
File Table Parameters'' on page 194.
Web: Tel Profile Settings Table
EMS: Protocol Definition > Telephony Profile
[TelProfile]
This ini file table parameter configures the Tel Profile table. Each Tel Profile
ID includes a set of parameters (which are typically configured separately
using their individual, "global" parameters). You can later assign these Tel
Profile IDs to other elements such as in the Endpoint Phone Number table
(TrunkGroup parameter). Therefore, Tel Profiles allow you to apply the same
settings of a group of parameters to multiple channels, or apply specific
settings to different channels.
The format of this parameter is as follows:
[TelProfile]
FORMAT TelProfile_Index = TelProfile_ProfileName,
TelProfile_TelPreference, TelProfile_CodersGroupID, TelProfile_IsFaxUsed,
To Next Page
Loading...
