AudioCodes MediaPack MP-124

SIP User's Manual 416 Document #: LTRT-65415
MediaPack Series
Parameter Description
'a=rtpmap:100 X-NSE/8000'.
 To use this feature:
9 The Cisco gateway must include the following definition:
'modem passthrough nse payload-type 100 codec
g711alaw'.
9 Set the Modem transport type to Bypass mode
(VxxModemTransportType is set to 2) for all modems.
9 Configure the gateway parameter NSEPayloadType =
100.
 This parameter can also be configured per IP Profile, using
the IPProfile parameter (see ''Configuring IP Profiles'' on
page 122).
EMS: NSE Payload Type
[NSEPayloadType]
NSE payload type for Cisco Bypass compatible mode.
The valid range is 96-127. The default value is 105.
Note: Cisco gateways usually use NSE payload type of 100.
Web: V.21 Modem Transport Type
EMS: V21 Transport
[V21ModemTransportType]
V.21 Modem Transport Type used by the device.
 [0] Disable = Disable (Transparent) - default
 [1] Enable Relay = N/A
 [2] Enable Bypass.
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured per IP Profile,
using the IPProfile parameter (see ''Configuring IP Profiles'' on
page 122).
Web: V.22 Modem Transport Type
EMS: V22 Transport
[V22ModemTransportType]
V.22 Modem Transport Type used by the device.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured per IP Profile,
using the IPProfile parameter (see ''Configuring IP Profiles'' on
page 122).
Web: V.23 Modem Transport Type
EMS: V23 Transport
[V23ModemTransportType]
V.23 Modem Transport Type used by the device.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events
Note: This parameter can also be configured per IP Profile,
using the IPProfile parameter (see ''Configuring IP Profiles'' on
page 122).
Web: V.32 Modem Transport Type
EMS: V32 Transport
[V32ModemTransportType]
V.32 Modem Transport Type used by the device.
 [0] Disable = Disable (Transparent)
 [1] Enable Relay = N/A
 [2] Enable Bypass = (default)
 [3] Events Only = Transparent with Events
Notes:
 This parameter applies only to V.32 and V.32bis modems.
 This parameter can also be configured per IP Profile, using
the IPProfile parameter (see ''Configuring IP Profiles'' on
page 122).