SIP User's Manual 428 Document #: LTRT-65415
MediaPack Series
Parameter Description
number can be as follows: d1005, dpp699, p9p300. To
add the 'd' and 'p' digits, use the usual number
manipulation rules.
To use this feature with FXO interfaces, configure the
device to operate in one-stage dialing mode.
If this parameter is enabled, it is possible to configure
the FXS/FXO interface to wait for dial tone per
destination phone number (before or during dialing of
destination phone number). Therefore, the parameter
IsWaitForDialTone (configurable for the entire device)
is ignored.
The FXS interface send SIP 200 OK responses only
after the DTMF dialing is complete.
This parameter can also be configured per Tel Profile,
using the TelProfile parameter.
Web/EMS: RFC 2833 Payload Type
[RFC2833PayloadType]
The RFC 2833 DTMF relay dynamic payload type.
The valid range is 96 to 99, and 106 to 127. The default is
96. The 100, 102 to 105 range is allocated for proprietary
usage.
Notes:
Certain vendors (e.g., Cisco) use payload type 101 for
RFC 2833.
When RFC 2833 payload type negotiation is used (i.e.,
the parameter TxDTMFOption is set to 4), this payload
type is used for the received DTMF packets. If
negotiation isn't used, this payload type is used for
receive and for transmit.
[ReplaceNumberSignWithEscapeChar]
Determines whether to replace the number sign (#) with
the escape character (%23) in outgoing SIP messages for
Tel-to-IP calls.
[0] Disable (default)
[1] Enable = All number signs #, received in the dialed
DTMF digits are replaced in the outgoing SIP Request-
URI and To headers with the escape sign %23.
Note: This parameter is applicable only if the parameter
IsSpecialDigits is set 1.
Web: Special Digit Representation
EMS: Use Digit For Special DTMF
[UseDigitForSpecialDTMF]
Defines the representation for ‘special’ digits (‘*’ and ‘#’)
that are used for out-of-band DTMF signaling (using SIP
INFO/NOTIFY).
[0] Special = Uses the strings ‘*’ and ‘#’ (default).
[1] Numeric = Uses the numerical values 10 and 11.
To Next Page
Loading...
Need help?
General
