Version 6.2 435 February 2011
SIP User's Manual 10. Configuration Parameters Reference
Parameter Description
configured in this table is sent in the SIP INVITE message's
From header.
The format of this parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index =
CallerDisplayInfo_DisplayString,
CallerDisplayInfo_IsCidRestricted;
[\CallerDisplayInfo]
Where,
Index = Port number (where 0 depicts Port 1).
DisplayString = Caller ID string (up to 18 characters).
IsCidRestricted =
9 [0] Allowed = sends the defined caller ID string when a
Tel-to-IP call is made using the corresponding device
port (default).
9 [1] Restricted = does not send the defined caller ID
string.
For example:
CallerDisplayInfo 0 = Susan C.,0; ("Susan C." is sent as the
Caller ID for Port 1)
CallerDisplayInfo 1 = Mark M.,0; ("Mark M." is sent as Caller
ID for Port 2)
Notes:
When FXS ports receive 'Private' or 'Anonymous' strings in
the SIP From header, the calling name or number is not
sent to the Caller ID display.
If the Caller ID name is detected on an FXO line (the
parameter EnableCallerID is set to 1), it is used instead of
the Caller ID name defined in this table parameter.
When the parameter CallerDisplayInfo_IsCidRestricted is
set to 1 (Restricted), the Caller ID is sent to the remote side
using only the SIP headers P-Asserted-Identity and P-
Preferred-Identity (AssertedIdMode).
To maintain backward compatibility, when the strings
‘Private’ or ‘Anonymous’ are entered in the parameter
CallerDisplayInfo_DisplayString, the Caller ID is restricted
and the value of the parameter
CallerDisplayInfo_IsCidRestricted is ignored.
The value of the parameter
CallerDisplayInfo_IsCidRestricted is overridden by the
parameter
SourceNumberMapIp2Tel_IsPresentationRestricted in the
'Source Number Manipulation' table (table parameter
SourceNumberMapIP2Tel).
For configuring this table using the Web interface, see
Configuring Caller Display Information on page 155.
For an explanation on using ini file table parameters, see
Configuring ini File Table Parameters on page 194.
Web/EMS: Enable Caller ID
[EnableCallerID]
Determines whether Caller ID is enabled.
[0] Disable = Disable the Caller ID service (default).
[1] Enable = Enable the Caller ID service.
If the Caller ID service is enabled, then for FXS interfaces,
To Next Page
Loading...
Need help?
General
