AudioCodes MediaPack MP-124 User Manual

SIP User's Manual 486 Document #: LTRT-65415
MediaPack Series
Parameter Description
Web: Add Number Plan and Type to RPI
Header
EMS: Add Ton 2 RPI
[AddTON2RPI]
Determines whether the TON/PLAN parameters are
included in the Remote-Party-ID (RPID) header.
 [0] No
 [1] Yes (default)
If the Remote-Party-ID header is enabled
(EnableRPIHeader = 1) and AddTON2RPI = 1, it's
possible to configure the calling and called number type
and number plan using the Number Manipulation tables
for Tel-to-IP calls.
Web/EMS: Source Manipulation Mode
[SourceManipulationMode]
Determines the SIP headers containing the source
number after manipulation:
 [0] = The SIP From and P-Asserted-Identity headers
contain the source number after manipulation
(default).
 [1] = Only SIP From header contains the source
number after manipulation, while the P-Asserted-
Identity header contains the source number before
manipulation.
Web: Redirect Number Tel -> IP
EMS: Redirect Number Map Tel to IP
[RedirectNumberMapTel2IP]
This ini file table parameter manipulates the redirect
number for Tel-to-IP calls. The manipulated Redirect
Number is sent in the SIP Diversion, History-Info, or
Resource-Priority headers.
The format of this parameter is as follows:
[RedirectNumberMapTel2Ip]
FORMAT RedirectNumberMapTel2Ip_Index =
RedirectNumberMapTel2Ip_DestinationPrefix,
RedirectNumberMapTel2Ip_RedirectPrefix,
RedirectNumberMapTel2Ip_NumberType,
RedirectNumberMapTel2Ip_NumberPlan,
RedirectNumberMapTel2Ip_RemoveFromLeft,
RedirectNumberMapTel2Ip_RemoveFromRight,
RedirectNumberMapTel2Ip_LeaveFromRight,
RedirectNumberMapTel2Ip_Prefix2Add,
RedirectNumberMapTel2Ip_Suffix2Add,
RedirectNumberMapTel2Ip_IsPresentationRestricted,
RedirectNumberMapTel2Ip_SrcTrunkGroupID,
RedirectNumberMapTel2Ip_SrcIPGroupID;
[\RedirectNumberMapTel2Ip]
For example:
RedirectNumberMapTel2Ip 1 = *, 4, 255, 255, 0, 0, 255, ,
972, 255, 1, 2;
Notes:
 This parameter table can include up to 20 indices (1-
20).
 The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and then Suffix2Add.
 If the table's matching characteristics rule (i.e.,
DestinationPrefix, RedirectPrefix, SrcTrunkGroupID,
and SrcIPGroupID) is located for the Tel-to-IP call,
then the redirect number manipulation rule (defined by

AudioCodes MediaPack MP-124 Specifications

General

Model	MediaPack MP-124
Category	Gateway
Protocols	SIP, H.323, MGCP
Voice Codecs	G.711, G.723.1, G.726, G.729A/B
Fax Support	T.38
Management	SNMP
Security	TLS/SRTP
Power Supply	100-240 VAC, 50/60 Hz
Operating Temperature	0°C to 40°C (32°F to 104°F)
Storage Temperature	-25 to 70°C
Humidity	10% to 90%, non-condensing
Analog Ports	24 FXS