SIP User's Manual 490 Document #: LTRT-65415
MediaPack Series
Parameter Description
To configure manipulation of source numbers for Tel-
to-IP calls using the Web interface, see ''Configuring
Number Manipulation Tables'' on page 129).
For a description on using ini file table parameters,
see ''Configuring ini File Table Parameters'' on page
194.
Web: Source Phone Number Manipulation Table for IP to Tel Calls
EMS: EMS: SIP Manipulations > Source IP to Telcom
[SourceNumberMapIP2Tel]
This ini file table parameter manipulates the source
number for IP-to-Tel calls. The format of this parameter is
as follows:
[SourceNumberMapIp2Tel]
FORMAT SourceNumberMapIp2Tel_Index =
SourceNumberMapIp2Tel_DestinationPrefix,
SourceNumberMapIp2Tel_SourcePrefix,
SourceNumberMapIp2Tel_SourceAddress,
SourceNumberMapIp2Tel_NumberType,
SourceNumberMapIp2Tel_NumberPlan,
SourceNumberMapIp2Tel_RemoveFromLeft,
SourceNumberMapIp2Tel_RemoveFromRight,
SourceNumberMapIp2Tel_LeaveFromRight,
SourceNumberMapIp2Tel_Prefix2Add,
SourceNumberMapIp2Tel_Suffix2Add,
SourceNumberMapIp2Tel_IsPresentationRestricted;
[\SourceNumberMapIp2Tel]
For example:
SourceNumberMapIp2Tel 0 =
22,03,$$,$$,$$,$$,2,667,$$,$$;
SourceNumberMapIp2Tel 1 =
034,01,1.1.1.1,$$,0,2,$$,$$,972,$$,10;
Notes:
This table parameter can include up to 20 indices.
The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and then Suffix2Add.
If the called and calling numbers match the
DestinationPrefix, SourcePrefix, and/or
SourceAddress conditions, then the RemoveFromLeft,
RemoveFromRight, Prefix2Add, Suffix2Add, and/or
LeaveFromRight are applied.
9 'x': represents single digits. For example:
10.8.8.xx represents addresses between
10.8.8.10 and 10.8.8.99.
9 '*' (asterisk): represents any number between 0
and 255. For example, 10.8.8.* represents
addresses between 10.8.8.0 and 10.8.8.255.
The following parameters are not applicable:
NumberType, NumberPlan and
IsPresentationRestricted.
To configure manipulation of source numbers for IP-
to-Tel calls using the Web interface, see ''Configuring
Number Manipulation Tables'' on page 129).
For a description on using ini file table parameters,
see ''Configuring ini File Table Parameters'' on page
To Next Page
Loading...
