Version 6.2 489 February 2011
SIP User's Manual 10. Configuration Parameters Reference
Parameter Description
[PerformAdditionalIP2TELDestination
Manipulation]
Enables additional destination number manipulation for
IP-to-Tel calls. The additional manipulation is done on the
initially manipulated destination number, and this
additional rule is also configured in the manipulation table
(NumberMapIP2Tel parameter). This enables you to
configure only a few manipulation rules for complex
number manipulation requirements (that generally require
many rules).
[0] = Disable (default)
[1] = Enable
Web: Source Phone Number Manipulation Table for Tel to IP Calls
EMS: SIP Manipulations > Source Telcom to IP
[SourceNumberMapTel2IP]
This ini file table parameter manipulates the source
phone number for Tel-to-IP calls. The format of this
parameter is as follows:
[SourceNumberMapTel2Ip]
FORMAT SourceNumberMapTel2Ip_Index =
SourceNumberMapTel2Ip_DestinationPrefix,
SourceNumberMapTel2Ip_SourcePrefix,
SourceNumberMapTel2Ip_SourceAddress,
SourceNumberMapTel2Ip_NumberType,
SourceNumberMapTel2Ip_NumberPlan,
SourceNumberMapTel2Ip_RemoveFromLeft,
SourceNumberMapTel2Ip_RemoveFromRight,
SourceNumberMapTel2Ip_LeaveFromRight,
SourceNumberMapTel2Ip_Prefix2Add,
SourceNumberMapTel2Ip_Suffix2Add,
SourceNumberMapTel2Ip_IsPresentationRestricted,
NumberMapTel2Ip_SrcTrunkGroupID,
NumberMapTel2Ip_SrcIPGroupID;
[\SourceNumberMapTel2Ip]
For example:
SourceNumberMapTel2Ip 0 =
22,03,$$,0,0,$$,2,$$,667,$$,0,$$,$$;
SourceNumberMapTel2Ip 0 =
10,10,*,255,255,3,0,5,100,$$,255,$$,$$;
Notes:
This table parameter can include up to 20 indices.
The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and then Suffix2Add.
If the called and calling numbers match the
DestinationPrefix and/or SourcePrefix conditions, then
the RemoveFromLeft, RemoveFromRight, Prefix2Add,
Suffix2Add, LeaveFromRight, NumberType,
NumberPlan, and/or IsPresentationRestricted are
applied.
An asterisk ('*') represents all IP addresses.
IsPresentationRestricted is set to 'Restricted' only if
'Asserted Identity Mode' is set to 'P-Asserted'.
The following parameters are not applicable:
NumberType and NumberPlan.
To Next Page
Loading...
Need help?
General
