SIP User's Manual 488 Document #: LTRT-65415
MediaPack Series
Parameter Description
For a description on using ini file table parameters,
see ''Configuring ini File Table Parameters'' on page
194.
Web: Destination Phone Number Manipulation Table for IP to Tel Calls
EMS: EMS: SIP Manipulations > Destination IP to Telcom
[NumberMapIP2Tel]
This ini file table parameter manipulates the destination
number of IP-to-Tel calls. The format of this parameter is
as follows:
[NumberMapIp2Tel]
FORMAT NumberMapIp2Tel_Index =
NumberMapIp2Tel_DestinationPrefix,
NumberMapIp2Tel_SourcePrefix,
NumberMapIp2Tel_SourceAddress,
NumberMapIp2Tel_NumberType,
NumberMapIp2Tel_NumberPlan,
NumberMapIp2Tel_RemoveFromLeft,
NumberMapIp2Tel_RemoveFromRight,
NumberMapIp2Tel_LeaveFromRight,
NumberMapIp2Tel_Prefix2Add,
NumberMapIp2Tel_Suffix2Add,
NumberMapIp2Tel_IsPresentationRestricted;
[\NumberMapIp2Tel]
For example:
NumberMapIp2Tel 0 = 03,22,$$,$$,$$,2,667,$$,$$;
Notes:
This table parameter can include up to 100 indices.
The manipulation rules are done in the following order:
RemoveFromLeft, RemoveFromRight,
LeaveFromRight, Prefix2Add, and then Suffix2Add.
If the called and calling numbers match the
DestinationPrefix, SourcePrefix, and/or
SourceAddress conditions, then the RemoveFromLeft,
RemoveFromRight, Prefix2Add, Suffix2Add, and/or
LeaveFromRight are applied.
The Source IP address can include the following
wildcards:
9 'x': represents single digits. For example:
10.8.8.xx represents addresses between
10.8.8.10 and 10.8.8.99.
9 '*' (asterisk): represents any number between 0
and 255. For example, 10.8.8.* represents
addresses between 10.8.8.0 and 10.8.8.255.
The following parameters isare not applicable:
SrcIPGroupID, NumberType, NumberPlan and
IsPresentationRestricted.
To configure manipulation of destination numbers for
IP-to-Tel calls using the Web interface, see
''Configuring Number Manipulation Tables'' on page
129).
For a description on using ini file table parameters,
see ''Configuring ini File Table Parameters'' on page
194.
To Next Page
Loading...
Need help?
General
