Avaya 1230 - Convert Unistim Software to SIP Software on the IP Deskphone

The Local Tools menu appears:
Table 14: Local Tools menu
1. Preferences
2. Local Diagnostics
3. Device Settings
4. Lock Menu
2. Select 3. Device Settings from theLocal Tools menu.
The Device Settings screen appears.
3. If you are using DHCP, select Yes.
If you are manually configuring the IP address, netmask, and gateway address, select No.
4. If the DHCP option is configured, the IP address is automatically obtained.
5. Configure the TFTP IP address within the IP Deskphone Device Settings menu.
This can be the provisioning server as defined in the chapter Creating the provisioning
files on page 45.
6. Select the Apply&Reset context-sensitive soft key to save the settings and reset the
IP Deskphone.
The IP Deskphone downloads the software file. The display shows [FW] reading….
If the download is successful, the display shows [FW] writing….
After the software image is downloaded to the IP Deskphone, the display shows [FW]
finished... and the IP Deskphone resets.
If the upgrade is unsuccessful, see the chapter
Maintenance on page 328 in the section
Download failures.
Convert UNIStim software to SIP software on the
IP Deskphone
If an IP Deskphone has UNIStim software installed, it runs with SIP software only if the software is
converted from UNIStim to SIP. If the procedure to determine the UNIStim version number is
completed, and, if necessary, the procedure to upgrade the UNIStim software is completed, an
IP Deskphone can be converted from UNIStim software to SIP software.
Compare the version number to the minimum required UNIStim software version (062AC5L ). If the
version number is not the minimum required version, see Upgrade to the minimum UNIStim
Software on page 124.
The conversion to SIP software must be performed using TFTP.
Convert UNIStim software to SIP software on the IP Deskphone
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 127
Comments? infodev@avaya.com