Avaya 1230 - Manual TFTP 12 Xxboot.cfg File Download

DHCP Option 66
The DHCP Option 66 supports TFTP, FTP and HTTP.
The DHCP option 66 URL is entered in the following format:
[<protocol name>://[<login>[:<password>]@]]<IP address or server
name>[:<port>][/<path>]
The square brackets [ ] indicate optional elements. The default protocol is TFTP, so if no protocol
precedes the IP address, TFTP is used. If the domain name of a server is used, then the DNS IP
address must also be defined.
Examples:
http://some_login@one_more.server.ca:80/config_folder
http://192.168.33.50
tftp://192.168.33.50
tftp://some.server.com
ftp://my_login:my_psw@test.server.org
12xxBoot.cfg file download
Assemble the components of the new IP Deskphone, as described in
Install the IP Deskphone on
page 115 or in the user guide of the appropriate IP Deskphone model. Plug in the IP Deskphone.
The IP Deskphone retrieves its IP address and provisioning information from DHCP. The IP
Deskphone reboots and then attempts to read the 12xxBoot.cfg from the provisioning server whose
IP address was supplied by DHCP. After reading the 12xxBoot.cfg file information, the IP
Deskphone downloads and installs the specified SIP software using the specified protocol and
provisioning server IP address. This can be the same provisioning server as the one where the
12xxBoot.cfg file is located.
Once the software image is installed, the IP Deskphone reboots again and looks for the standard
SIP config files listed in the following table. The IP Deskphone then follows the 12xxSIP.cfg file
instructions.
Model
Config file name
1220 IP Deskphone 1220SIP.cfg
1230 IP Deskphone 1230SIP.cfg
Related Links
Downloading the 12xxBoot.cfg file on page 118
Manual TFTP 12xxBoot.cfg file download
Use the following procedure to perform a manual download of the 12xxBoot.cfg file to the IP
Deskphone.
Downloading the 12xxBoot.cfg file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 119
Comments? infodev@avaya.com