DNS IP1 and DNS IP2
Configure the Domain Name Servers (DNS) IP addresses DNS IP1 and DNS IP2.
Ntwk Port Speed
There are three options to provision the network port speed.
• Auto – Link speed is auto negotiated with the network device and attached PC.
• 10BT – Link speed is available for up to 10 Megabit Full Duplex on the network and the PC
port.
• 100BT – Link speed is available for up to 100 Megabit Full Duplex on the network and the PC
port.
Ntwk Port Duplex
There are three options available to provision the Network Port Duplex for Network Port Speed of
10BT or 100BT.
• Auto – duplex is autonegotiated. Avaya recommends that Auto Negotiate mode is used on the
network and the IP Deskphone.
• Force Full – duplex is forced to FULL. Use Force Full mode only when the network is forced
Full Duplex. Otherwise a duplex mismatch results.
• Force Half – duplex is forced to HALF. Use Force Half mode only when the network is forced
Half Duplex. Otherwise a duplex mismatch results.
Disable Voice 802.1Q
If 802.1Q is disabled, standard Ethernet frames are transmitted. If 802.1Q is enabled, all frames
transmitted by the Ethernet driver have the 802.1Q tag bytes inserted between the source MAC
address and the protocol type field.
Voice VLAN
Configure the Voice VLAN.
Device Settings on the IP Deskphone with SIP Software
154 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com
To Next Page
Loading...
