Avaya 1230 - Dhcp

TLV Fields
Unknown Policy Flag (U)—1 only if the policy is unknown
Tagged Flag (T)—configure accordingly Reserved (X)-0
VLAN ID—configure accordingly
L2 Priority—configure accordingly
DSCP Value—configure accordingly
Location Identification Discovery Coordinate-based LCI–16 bytes
Civic Address LCI I–variable length
This format can have more than one address element and one
address element can range from a minimum of 7 to 256 bytes.
ECS ELIN I–variable between 10 and 25 bytes
Although location is received, it is not available to end user in this
release of the SIP Software.
Extended Power-via MDI Discovery Power Type = 01–PD Device
Power Source = 00–Unknown
There is no hardware support for determining the power source.
Power Priority = 0010–High
Power Value = Maximum power required as shown below:
1220 =
1230 =
Software Revision Configure to the software version being used; for example,
0604D97.
Manufacturer Name “avaya-xy”,
where: xy is a 2-digit manufacturer code as shown below:
1220: Code 04
1230: Code 04
Model Name Contains a string, which specifies the IP Deskphone model, for
example, “IP Deskphone xxx”, where, xxx is one of the following
values: 1220, 1230.
DHCP
There are two methods of provisioning DHCP.
1. No DHCP (Manual configuration): All the Device Settings parameters are configured
manually on the IP Deskphone with SIP Software.
Device Settings on the IP Deskphone with SIP Software
152 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com