Avaya 1230 - Auto Login Parameters in Server Profiles

• 2 — second profile
• 3 — all profiles
• any other value — all profiles
Auto Login parameters in server profiles
In SIP 4.4 and later, a user can now have a different auto-login for each server.
If the IP Deskphone configuration parameter AUTOLOGIN_ENABLE is configured as 2 or
USE_AUTOLOGIN_ID, then the UserID, AuthID, and Passwd values are extracted from the
AUTOLOGIN[_ID_KEY|_AUTHID_KEY|_PASSWD_KEY] configuration parameters.
Server profiles support all configurations of the AUTOLOGIN_ENABLE parameter.
If the AUTOLOGIN_ENABLE parameter in a profile is configured as 0 (or NO) or 1 (or YES), then
the configuration file behaves as if there was no profile.
If the AUTOLOGIN_ENABLE parameter in the profile is configured as 2 (or USE_AUTOLOGIN_ID),
the IP Deskphone performs a soft reset. After the soft reset, users specified by the
AUTOLOGIN[_ID_KEY|_AUTHID_KEY|_PASSWD_KEY] configuration parameters are logged in.
If the profile does not contain the AUTOLOGIN_ENABLE parameter, the parameter from the System
Configuration file is used.
Note:
Auto login user names and passwords are not printed using the prtcfg command as they are
not stored in the system configuration file and are secure parameters which should not be
displayed.
Example of Auto-Login parameters in config file
The following example shows the AUTOLOGIN parameters as they might be used in phone’s config
file. In this example, the PROMPT_AUTHNAME_ENABLE is YES, so the
AUTOLOGIN_AUTHID_KEYnn parameter is included for each login.
AUTOLOGIN_ENABLE USE_AUTOLOGIN_ID
PROMPT_AUTHNAME_ENABLE YES
# DN Key 1
AUTOLOGIN_ID_KEY01 7903@mydomain.com
AUTOLOGIN_AUTHID_KEY01 steven
AUTOLOGIN_PASSWD_KEY01 7654
# DN Key 2
AUTOLOGIN_ID_KEY02 7904@mydomain.com
AUTOLOGIN_AUTHID_KEY02 steven
AUTOLOGIN_PASSWD_KEY02 7654
Features
210 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com