Avaya 1230 - Requirements

Requirements
Ensure that the following requirements for migration have been implemented:
• The IP Deskphones are running UNIStim Release 3.3 firmware release or newer.
The latest firmware is recommended - 062xC8Q.
• DHCP is enabled on the IP Deskphones .
The DHCP option should be set to YES in the Network Configuration menu.
• Auto Provisioning for the Provisioning Server is enabled on the IP Deskphones.
Check the Provision Server option check box in the Network Configuration > Auto menu.
• There is access to Avaya IP Office Manager.
• There are no network outages during migration.
The DHCP server, the CS 1000 system, and Avaya IP Office are available in the network.
• There are no power outages during the migration.
A power outage during the software upgrade can cause corruption of the IP Deskphone
software. As a result, the IP Deskphone might not be able to start up and may require repair.
Related Links
Migrating IP Deskphones with UNIStim firmware from CS 1000 to IP Office on page 401
Before you begin
Obtain the SIP software images for the IP Deskphones. SIP Software Release 4.4 or later is
recommended.
Related Links
Migrating IP Deskphones with UNIStim firmware from CS 1000 to IP Office on page 401
Migrating IP Deskphones with UNIStim firmware from CS
1000 to IP Office
About this task
If you have IP Deskphones running UNIStim firmware on a CS 1000 system, and you want to
migrate the IP Deskphones to Avaya IP Office, use the following procedure.
Migrating IP Deskphones with UNIStim firmware from CS 1000 to IP Office
402 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com