Avaya 1230 - Page 151

TLV Fields
Bit 0 = 1 [Auto-negotiation supported]
Bit 1 = 1 or 0, depending on the current auto-negotiation status,
for example, either enabled or disabled.
PMD auto-negotiation advertised capability =
0x4000 - 10BASE-T half duplex mode
0x2000 - 10BASE-T full duplex mode
0x0800 - 100BASE-TX half duplex mode
0x0400 - 100BASE-TX full duplex mode
Operational MAU Type =
10 – UTP MAU, 10BT, half duplex mode
11 – UTP MAU, 10BT, full duplex mode
15 - 2-pair Category 5 (CAT5) UTP, 100BT, half duplex mode
16 - 2-pair CAT5 UTP, 100BT, full duplex mode
Power Via MDI MDI power support = 0:
Bit 0 = 0 – Powered Device
Bit 1 = 0 – PSE MDI power not supported
Bit 2 = 0 – PSE MDI power state disabled
Bit 3 = 0 – PSE pair selection can not be controlled
PSE power pair = 1
Power Class = 2 for 1220/1230 IP Deskphones
Link Aggregation Aggregation status = 0; the link is not capable of being
aggregated, and currently is not in aggregation.
Aggregated Port ID = 0
Maximum frame size The MAC/PHY supports an extension of the basic MAC frame
format for Tagged MAC frames. The maximum frame size is
configured to 1522.
LLDP-MED System Capabilities Bit 0 = 1—LLDP-MED Capabilities–supported
Bit 1 = 1—Network Policy–supported
Bit 2 = 1—Location Identification–supported
Bit 3 = 0—Extended Power using MDI-PSE–not supported
Bit 4 = 1—Extended Power using MDI-PD–supported
Bit 5 = 1—Inventory–supported
The Class Type field can be configured to 3 -Telephone
Network Policy Discovery Application Type-1—voice
Table continues…
TLVs
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 151
Comments? infodev@avaya.com