3. Configure the IP Deskphone Device Settings TFTP IP address to the IP address where your
TFTP server is running.
After you are finished the configuration, the IP Deskphone reboots and sends a request to
the TFTP server.
4. Select the Apply&Reset context-sensitive soft key to save the settings and reset the
IP Deskphone.
The following messages display on the IP Deskphone as the IP Deskphone cycles through
the conversion process, one after the other:
a. [FW] Reading...
b. [FW] Writing...
c. [FW] Finished...
The IP Deskphone then boots up with SIP Software.
If the conversion is unsuccessful, see the chapter Maintenance on page 328.
1. TFTP file transfer takes approximately 15 seconds.
2. File writing takes 2.5 minutes. The IP Deskphone displays the message [FW] writing….
3. After the new SIP software writing is finished, the IP Deskphone displays [FW] Finished.... and
then reboots.
4. The first time the SIP software boots, the SIP software performs a Flash File System conversion
that takes 2.5 minutes.
Convert UNIStim software to SIP software on the IP Deskphone
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 129
Comments? infodev@avaya.com
To Next Page
Loading...
