The default value of the stickiness attribute is AUTO. If the provisioning parameter is AUTO, the IP
Deskphone can receive the value from automatic provisioning sources based on the precedence
rule. If you manually change the parameter, the attribute value is MANUAL. If the attribute is
MANUAL, the provisioning information from automatic provisioning sources is ignored, except for
the standard DHCP parameters. The AllAut softkey in the Device Setting’s Auto dialog will return all
parameters to AUTO. The Set to Factory Default function returns all parameters to AUTO as well as
resetting their value to the factory default value.
If you enable DHCP, then the IP address, the subnet mask, and the default gateway, which the IP
Deskphone obtains from the DHCP server, overwrites the manually configured value. The value for
EAP device ID and password can also overwrite the manually configured value. If you configure
stickiness and the current provisioning source does not provide the provisioning information for the
particular parameter, the last received provisioning value is used.
Parameter source precedence rules
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 141
Comments? infodev@avaya.com
To Next Page
Loading...
