Avaya 1230 - Page 353

• Press Config soft key to return to the Network Settings window.
• Check the Enable SSH checkbox.
3. Enter the UserID and Password.
4. Press the Apply soft key.
5. Connect to the IP Deskphone by using any SSH client program.
Enabling SSH through provisioning:
To enable SSH on an IP Deskphone through provisioning, perform this procedure:
1. Open the Device Settings dialog.
2. Check to see if the Enable SSH parameter checkbox is displayed and the checkbox is
checked. If the Enable SSH parameter checkbox is not displayed, do the following:
• Press the Auto soft key and check the 18. SSH Enable checkbox in the Auto Provisioning
window.
• Press the Config soft key to return to the Network Settings window.
• Check the Enable SSH checkbox.
3. Add the following parameters to the IP Deskphone device configuration file:
•
SSH YES
•
SSHID <user name>
•
SSHPWD <user password>
.
4. Press the Services soft key and select 4.Check for Update. Press the YES soft key to
update the IP Deskphone configuration.
5. Connect to the IP Deskphone by using any SSH client program.
The PDT supports the following set of commands:
Table 121: List of PDT commands
#
Command Description
1 prtlog >prtlog<mngr_dest> • Prints the content of the ECR-log file.
• Outputs content of the specified log file to stdout (the
screen, a stream, stdout, or a string). The input
parameter specifies a type of logging manager:
- 0 (default) — ECR-log file
- 1 — SIP-log file
If the input parameter is incorrect, the following
notification appears:
>prtlog: incorrect type of manager <x>
2 clearLogFile Clears the content of the ECR-log file
Table continues…
PDT commands
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 353
Comments? infodev@avaya.com