Avaya 1230 - Page 69

- NO (or 0) - turns off the auto login feature.
- USE_AUTOLOGIN_ID (or 2) - enables the auto login id feature using the userid specified in
AUTOLOGIN_ID_KEY01 and the password specified in AUTOLOGIN_PASSWD_KEY01 to
register and authenticate. Both userid and password must be specified.
The AUTOLOGIN_ID_KEY01 and AUTOLOGIN_PASSWD_KEY01 parameters are defined
in the IP Deskphone-specific configuration file.
Note:
When USE_AUTOLOGIN_ID is used, the user is prevented from logging off the
IP Deskphone.
Note:
If AUTOLOGIN_ENABLE is configured as USE_AUTOLOGIN_ID (2) in the IP Deskphone-
specific configuration file, it is recommended that AUTOLOGIN_ENABLE be configured as
YES (1) or NO (0) in the device configuration file.
This makes it easier to reconfigure an IP Deskphone that used the IP Deskphone-specific
configuration file to use only the device configuration file. Otherwise a phone may try to
login with the old IP Deskphone-specific configuration file auto-login parameters.
• AUTOLOGIN_AUTHID_KEYxx — is used for auto login when the AUTOLOGIN_ENABLE
method is configured to USE_AUTOLOGIN_ID (or 2).
If the config file does not contain AUTOLOGIN_AUTHID_KEYxx, the client uses the value
from AUTOLOGIN_ID_KEYxx.
• PROMPT_AUTHNAME_ENABLE — is used to determine if the authentication ID screen is
presented to the user. The default value is NO.
- YES - after the user login name is entered, the authentication ID screen appears.
- NO - after the user login name is entered, the password screen appears.
• AUTO_UPDATE [YES | NO] — is a command to enable or disable the automatic updating of
the IP Deskphone with SIP Software configuration files from the provisioning server. Enabling
this command causes the IP Deskphone with SIP Software to check for updates once every
day. The default is disabled.
- YES - turns on the AUTO_UPDATE feature.
- NO - turns off the AUTO_UPDATE feature.
Note:
If the IP Deskphone encounters any Major or Critical error in memory during the Auto
update process, the IP Deskphone reboots based on the recovery level configured.
• AUTO_UPDATE_TIME [x] — is the actual time in seconds, starting from midnight, before an
automatic update occurs. Each IP Deskphone adds random numbers to the time specified by
this command so that every IP Deskphone does not try to access the provisioning server at the
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 69
Comments? infodev@avaya.com